Note:

Handles and QD Connectors

The Bass50 and Universal Port feature QD Bolts which allow you to quickly attach/detach the handles. We recommend leaving the handles attached during setup to easily lift and move your components.

Step 01:

Prep the Bass50s

Remove the 4 grille-side feet from the Bass50s.

Replace the hex bolts, leaving the side bolts slightly unscrewed.

Step 02:

Attach Latches to Bass50s

Slide the 4 latches over the loosened side bolts, then tighten the bolts to hold the latches firmly in place.

Step 03:

Place Bass50s On Dollies

Place the Bass50s on the dollies, grille-side up:

• Hook the battery-side feet under the cleats.
• Lower the control-side feet down into thelatches so they lock firmly in-place.

NOTE: make sure the wheels are locked to prevent the dollies from moving during setup.

We recommend facing the control panel away from the crowd for ease of access to wiring and controls and a cleaner look.

Step 05:

Attach Speaker Poles

Screw the threaded end of the Trulli Speaker Poles into the tops of the Universal Ports. Make sure the poles are screwed in all the way and that there is no gap between the bottom of the pole and the top of the port.

Step 06:

Attach Top Speakers

Place your top speakers on the Speaker Poles, then rotate the tightening ring to secure them in place.

Step 07:

Setup Controller & Source Device

Place your controller/mixer and source device in the area.