Note:

Handles and QD Connectors

The Bass50 and Universal Port feature QD Bolts which allow you to quickly attach/detach the handles. We recommend leaving the handles attached during setup to easily lift and move your components.

Step 01:

Prep the First Bass50

Remove the 4 grille-side feet from the first Bass50.

Replace the hex bolts, leaving the side bolts slightly unscrewed.

Step 02:

Prep the Second Bass50

Remove all 8 feet from the second Bass50.

Replace the hex bolts on the grille-side and the sides. Same as the first Bass50, leave the side bolts closest to the grille slightly unscrewed.

Set aside the 4 non-grille-side bolts for now, you will use these to attach the M20 Plate in Step 08.

NOTE: you can attach the M20 Plate at this point, but it will make the unit heavier to lift.

Step 03:

Attach Latches to Bass50s

Slide the 8 latches over the loosened side bolts, then tighten the bolts to hold the latches firmly in place.

Step 04:

Place Bass50 On Dolly

Place the first Bass50 on the dolly, grille-side up:

• Hook the battery-side feet under the cleats.
• Lower the control-side feet down into thelatches so they lock firmly in-place.

NOTE: make sure the wheels are locked to prevent the dolly from moving during setup.

We recommend facing the control panel away from the crowd for ease of access to wiring and controls and a cleaner look.

Step 06:

Attach Second Universal Port

Place the second Universal Port on top of the first, with the large opening facing up. Make sure the ports’ feet are aligned, then place the Stacking Clamps over the feet and tighten the knobs to secure the ports together.

Step 07:

Attach Second Bass50

Place the second Bass50, grille-side down, on top of the stack, making sure to align the 4 hex bolts with the spacers on the port.

Connect and tighten the latches to secure the Bass50 to the port.

Step 08:

Attach M20 Plate

Place the M20 Plate on the Bass50, making sure to align the bolt holes.

Use the bolts you set aside in Step 02 to secure the plate to the Bass50.

Step 09:

Attach Speaker Pole

Screw the threaded end of the Trulli Short Speaker Pole into the top of the M20 Plate. Make sure the pole is screwed in all the way and that there is no gap between the bottom of the pole and the top of the plate.

NOTE: you can hang sandbags off the sides of the M20 Plate to add additional weight.

Step 10:

Attach Top Speaker

Place your top speaker on the Speaker Pole, then rotate the tightening ring to secure it in place.